Transmission Lever - Duerkopp Adler 868 Service Instructions Manual

2.4.2

Transmission lever

1
Caution: Risk of injury !
Turn the main switch off !
Check and set the transmission lever only with the sewing
machine switched off.
6
The lever 3 transmits the movement of the advance shaft to the needle
bar linkage.
2
Loosen the clamping screw 6 on the lever 2.
–
–
Correctly position the needle bar linkage by using the setting
5
gauge 1 (0868 290194).
Loosen the pressure screws on the lever 3 (2x).
–
Put the setting gauge 4 (0868 290020) onto the bolt 5 and push it
–
4
downward until the limit stop.
Tighten the clamping screw 6 on the lever 2.
–
–
Set the upper stitch setting wheel (see chapter 2.3.2) to "0".
Tighten the pressure screws on the lever 3 (2x).
–
Remove the setting gauges 1 and 4.
–
3
5
4
GB
17