Programming - Chamberlain PowerDrive PD210 User Manual

Operation

Programming

NOTICE: If this Security+ ® garage door opener is operated with a non-rolling code transmitter, the
technical measure in the receiver of the garage door opener, which provides security against code-theft
devices, will be circumvented. The owner of the copyright in the garage door opener does not authorize
the purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure.
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LED will glow steady for 30
seconds. Within 30 seconds...
3. Press and hold the button on the remote control that you wish to use.
Release the button when the garage door opener lights blink or two clicks are heard.
When replacing the light lens cover, ensure the antenna wires are hanging straight down.
1
LEARN LED
PROGRAM A REMOTE CONTROL USING THE MULTI-FUNCTION DOOR CONTROL
1. Press and hold the button on the hand-held remote* that you wish to operate your garage
door.
2. While holding the remote button, press and hold the LIGHT button on the Multi-Function Door
Control. Continue holding both buttons while you press the push bar on the Multi-Function
Door Control (all three buttons are held).
3. Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not
installed, two clicks will be heard.
1
OR OR
2
LEARN
Button
3
2
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
*3-BUTTON REMOTES
If provided with your garage door opener, the large button is factory programmed to operate it. Additional
buttons on any Security+ ® 3-Button remote or compact remote can be programmed to operate other
Security+ ® garage door openers.
36