Install The Door Control - Chamberlain 1260 - 1/2HP Owner's Manual

Installation Step 6

Install the Door Control

• Strip 1/4" of insulation from one end of the bell
wire; connect the wire to the two screw terminals
on the back of the Door Control by color:
white to 2 and white/red to 1.
• Locate the Door Control within sight of the door
at a minimum height of 5 feet where small
children cannot reach, and away from all
moving parts of the door and door hardware.
Fasten the Multi-Function Door Control Panel
securely with 6ABx1" screws. Fasten the Lighted
Door Control Button securely with 6ABx1-1/2"
screws. If installing into drywall, drill 5/32" holes
and use the anchors provided.
• Run the bell wire up the wall and across the ceiling
The Chamberlain Group, Inc
to the opener. Use insulated staples to secure the
wire in several places. Be careful not to pierce the
Step 6 Install Lighted Door Control Button
wire with a staple, thereby resulting in a short.
CGI Multifunction/Pushbutton
• Receiver terminals and the antenna are located on
10/8/91 - 5/2/92 - 5/4/92 - 5/26/92
the back panel of the opener. Position the antenna
wire as shown.
• Then connect the bell wire to the opener terminal
screws: white to 2 and white/red to 1.
• Remember to affix the User Safety Instruction
label to the wall near the Door Control, and the
Maintenance Instruction label in a prominent
location on the inside of the garage door.
If the label adhesive will not adhere to your garage
wall surface (or becomes loose with time) use tacks
to secure the label alongside the Door Control.
Page 28 explains how to operate the opener using
the door controls and the Lock & Light features
available on the Multi-Function Door Control Panel.
Hardware Shown Actual Size
6ABx1-1/2" Screw
Lighted Door Control Button
6ABx1" Screw
Multi-Function Door Control Panel
Lighted
Door Control
Button
Insulated
Staples
Dry Wall Anchors
2-Conductor
Bell Wire
Lock Button
LO C K
LI G H T
Light Button
Door Control
Push Bar
Multi-Function
Door Control Panel
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death.
Install the Door Control (or any additional push
buttons) out of the reach of children and away
from all moving parts of the door and door
hardware, but where the garage door is visible.
Do not allow children to operate the push
button(s) or the remote control transmitter(s).
A moving garage door could injure someone
under it. Activate the opener only when the
door is properly adjusted, you can see it
clearly, and there are no obstructions to door
travel.
Do NOT connect the power and operate the
opener at this time. The trolley will travel to the
full open position but will not return to the
close position until the sensor beam is
connected and properly aligned.
See Safety Reversing Sensor Instructions
beginning on page 17.
Outside Keylock Accessory Connections
To opener terminal screws:
white to 2 and white/red to 1
Models 1255 & 1245
2-Conductor
Bell Wire
Lighted
Door
Control
Terminal
Screws
Back Panel
of Opener
14
WARNING
Models 1260 & 1250
Multi-Function
Door Control Panel
Terminal Screws
2-Conductor
Bell Wire
RE D -1
WH ITE -2
Opener
Terminal
Screws
1 2
9
1
7 3
5
KG
Antenna
3
9
1
7 3
5
KG