Removing And Reinstalling The Front Bezel; Removing And Reinstalling The Pci Card Holder - Lenovo ThinkStation C30 Hardware Maintenance Manual

Removing and reinstalling the front bezel

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
Safety Information" on page 1.
This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 80.
3. Remove the front bezel by releasing the two plastic tabs on the left side and pivoting the front bezel
outward.
Figure 7. Removing the front bezel
4. To reinstall the front bezel, align the three plastic tabs on the right side of the front bezel with the
corresponding holes in the chassis, then pivot the front bezel inwards until it snaps into position on
the left side.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 127.

Removing and reinstalling the PCI card holder

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
Safety Information" on page 1.
.
Chapter 10 Replacing FRUs
81