Eclipse CD3000 Owner's Manual page 59

AUTH_ERR
ANTENNA
CALL 888-539-
SIRIUS
ACQUIRING
NO iPod
READING
NO DATA
ERROR 1
ERROR 2
Mode Problem
Dead or weak
sound
Power does not
turn on.
Common
to all
Frequencies or
titles set in
memory are
deleted.
No guide tone
sounds.
The remote
control does not
work.
AREA SHOT DATA
CANNOT BE IMPORTED
PROPERLY
Sirius ANTENNA IS
DISCONNECTED
NO SUBSCRIPTION TO
THE SELECTED CHANNEL
Sirius Satellite RADIO
SIGNAL RECEIVING FAILS
NO iPod IS CONNECTED
THE iPod IS IN DATA
COMMUNICATION
NO SONGS ARE STORED
IN THE iPod
DATA COMMUNICATION
WITH THE iPod IS
INTERRUPTED FOR SOME
REASONS
THE SOFTWARE IS NOT
ADAPTABLE
Causes
Is the volume control up sufficiently?
Is the muting function in effect (MUTE)?
Is the fader or balance control set far to one
side?
Other probable causes include broken
audio-signal wiring or a faulty speaker.
Are there too electrical items installed and
causing a lack of power?
Other probable causes include a run-down
car battery, broken power or
interconnection wiring.
Has the car battery been disconnected for
repair or checked out?
Are there too electrical items installed and
causing lack of available power?
Other probable causes include run-down
car battery, broken power or
interconnection wiring.
Is the guide tone disabled?
Is the battery low?
Is the battery installed in reverse polarity?
Is direct sunlight hitting the remote control
light receptor?
Other probable causes include a
malfunctioning remote control.
If you have a question:
Confirm the CD-R data.
Connect the Sirius antenna.
Subscribe to Sirius to receive the service by Sirius
Satellite radio.
Select another channel.
Connect the iPod correctly.
Wait for a while until the message disappears.
Check if music data are stored in the iPod
Check if the iPod is correctly connected.
Check the iPod software.Refer to the Instruction
Manual of the iPod interface adaptor (IPC-106).
Remedial action
to take
Turn up the volume control.
Cancel the muting (MUTE)
function.
Readjust the fader and
balance controls to more
normal positions.
Have your dealer check the
problem.
Have your dealer check the
problem.
Have your dealer check the
problem.
Reenter them into memory.
Have your dealer check the
problem.
Have your dealer check the
problem.
Enable the guide tone.
Replace battery.
Reinstall the battery in the
correct polarity.
Use the remote control close
to the receptor.
Have your dealer check the
problem.
Refer to
page
36
36
36
—
—
—
24
—
—
43
XVIII
27
27
—
—
59