5.6 Fitting the control panel
The machine head provides 2 threaded holes for fastening the control panel.
–
Fasten the external control panel 2 by a square and 2 screws at a side of the
sewing machine head.
–
Lead the connection cable of the control panel 2 through the table top cut-out and
pass it down.
–
Introduce the plug of the connection cable into the bush B776 of the drive
controller.
5.7 Fitting the sewing lamp
–
Stick the adhesive label with the safety indication to the front of the main switch.
–
Remove the bobbin cover.
–
Fasten the holder 3 to the bobbin cover by the screw 4 and the toohted washer 5
(see picture).
–
Place the sewing lamp.
–
Install the incoming cable in its duct.
–
Lead the connection cable through the hole in the table top and pass it down.
–
Fasten the sewing lamp transformer by chip board screws to the table top.
–
Fasten the connection cable by cable binder under the table top.
–
Connect the incoming cable to the sewing lamp transformer by a plug-in connector.
NOTE!
The sewing lamp will be supplied with current also when
the main switch is turned off.
13