6. Flex the retaining clips as shown to remove the hard disk drive from the bracket.
Figure 120. Removing the hard disk drive from the bracket
7. To install a new hard disk drive into the bracket, flex the bracket and align pin
5
on the bracket with the corresponding holes in the hard disk drive.
Important: Do not touch the circuit board
8. Connect the signal cable and the power cable to the new hard disk drive.
.
Chapter 10
Replacing FRUs (machine types: 2756, 2800, 2929, 2932, 2934, 2941, 2945, 2961, 2982, 2988, 2993, 2996, 3181,
3
on the bottom of the hard disk drive.
3183, 3185, 3187, 3198, 3202, 3207, 3209, 3214, 3218, 3224, 3227, 3306, 3393, and 3395)
1
, pin
2
, pin
4
, and pin
177