Boot Options; Operating System Installation - HP Xw25p - ProLiant - Blade Workstation User Manual

Hp rom-based setup utility user guide
Hide thumbs Also See for Xw25p - ProLiant - Blade Workstation:
Table of Contents

Advertisement

Drives Installed
1
2
3, 4, 5, or 6
More than 6
NOTE:
system, ORCA does not automatically configure the array. If this occurs, you must run ORCA to
configure the array settings.
By default, the auto-configuration process configures the system for a default operating system. To change
any default settings in the auto-configuration process, such as the settings for language, operating system,
and primary boot controller, execute RBSU by pressing the F9 key after system POST. After the settings
are selected according to your preference, exit RBSU and reboot the server.

Boot options

Near the end of the boot process, the boot options screen is displayed. This screen is visible for several
seconds before the system attempts to boot from a supported boot device. During this time, you can do
the following:
Access RBSU by pressing the F9 key.
Access the System Maintenance Menu (which enables you to launch ROM-based Diagnostics or
Inspect) by pressing the F10 key.
Force a PXE Network boot by pressing the F12 key.

Operating System Installation

For an assisted operating system installation, insert the SmartStart CD into the CD-ROM drive to begin the
installation process. The operating system and server support software are installed upon completion of
this process.
Drives Used
1
2
3, 4, 5, or 6
0
If the boot drive contains logical volumes, or if more than six drives are installed on the
RAID Level
RAID 0
RAID 1
RAID 5
None
ROM-based enhancements 117

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rom-based setup utility

Table of Contents