Main Setup; Advanced Settings; Ide Configuration - TYAN Thunder i7501 Pro S2721-533 Manual

3.1 – Main BIOS Setup
In this screen, you can alter general features such as the date and time, as well as access the IDE
configuration screens. Note that the options listed below are for options that can directly be
changed within the Main Setup screen.
System Time
System Date
Master/Slave Setup
All the options in this section are automatically detected by the motherboard chipset and BIOS.
You do not need to configure this section.
3.2 – Advanced Settings

IDE Configuration

Floppy Configuration
Boot Settings Configuration
Super IO Configuration
Remote Access Configuration
Onboard Device Configuration
USB Configuration
3.3 – IDE Configuration
Options related to the IDE controller can be altered through the following.
Onboard PCI IDE
Controller
Primary Master/Slave
Secondary Master/Slave
Hard Disk Write Protect
ATAPI Detect Time Out
ATAPI 80pin Cable
Detect
The System Time will always display the current time in a 24-hour
format. You may adjust the System Time according to your location.
Adjusting the clock in your operating system will also change the
System Time inside BIOS setup.
System Date displays the current date and can be changed just like
System Time.
All settings discussed in following sections.
Both
Primary
Secondary
Auto
Disabled
Enabled
Disabled
0, 5, 10, 15, 2.0x,
2.5x, 3.0x, 3.5x
Host & Device
Host
Device
26
http://www.TYAN.com
Leave as Default. This setting toggles the
onboard IDE drive controller on or off.
Leave as Default. This setting toggles the
detection of drives attached to the IDE
controller
Toggles the use of boot sector protection.
This ensures that no viruses can damage the
hard drive.
Defines how long the system will try to detect
ATAPI devices for.
Toggles the detection of 80wire IDE cables.