Rec Function - Tascam DA-88 Owner's Manual

7. To punch out of record, press the footswitch again.
8.
To stop the tape, press
STOP.
In tbis example, we. will "bounce" or combine material from tracks 1-4 onto
etnpty track 8.
I. Connect outputs 1.4 of the DA-88 to inputs I-4 of your mixer, and connect
group out I of the mixer to input 8 of the DA-88.
2. Set the mixer controls as required (assign channels 1-4 to group out 1, bring up
the group 1 monitor level control, etc).
3. Press the
REC FUNCTION
switch for track 8 to put this into Ready mode. All
other tracks should be in Safe mode.
4. Locate the tape to the beginning of the selection, then press
PLAY.
5. Slowly increase the group 1 fader until meter 8 peaks at 0 dB. Use the channel
faders (and EQ controls) to set each track's relative level for the desired balance.
6. When the record level setting is complete, rewind the tape back to the
beginning of the selection.
7. Hold RECORD and press PLAY. Tracks I-4 will be mixed into track 8.
8. At the end of the selection, press
STOP,
and rewind the tape to the beginning
of the recording just done.
9, Put track 8 into Safe mode by pressing its REC FUNCTION switch again, then
press
PLAY to
audition the mix on track 8. If track 8 does not sound right,
make the necessary corrections and redo from the beginning.
Repeat bouncing :
Once you we totally satisfied with the mix on track 8, you can record new material
o" tracks 1-4, then bounce them o"to track 7 or any other empty track the sane
way you bounced onto track 8.
20