Tascam DA-88 Owner's Manual page 15

5. At the desired punch-in point, hit
RECORD.
The REC FUNCTION indicator
which was blinking will turn cm solid.
6.
Hit
PLAY to
punch mt of record. The tape will resume playing and the REC
FUNCTION indicator will start blinking as before.
REC FUNCTION-triggered punch-in
I. Check to see that aI1 the
REC FUNCTION
indicators are off.
2. Press
INSERT town on its
LED.
3. Locate the tape to a point a few seconds lower than the expected punch-in
point.
4. Hold
RECORD
and press
PLAY to
let the tape start playing in Record Ready
mcde.
5. At the desired punch-in point, hit the punch-in track's
REC FUNCTION
switch.
6. At the punch-out point, hit the same
REC FUNCTION
switch again. The
transport will go into Play mode.
Foobwikh-triggered punch-in
The optional RG3OP footwitch allows you to
achieve no-hands punch-in and out.
1. Plug the RC-30P footswitch into the REMOTE PUNCH ON/OUT jack on the
deck's rear.
2, Locate the tape to a point a few seconds lower than the expected punch-in
point.
3. Put the punch-in track into Ready mode by pressing its
REC FUNCTION
switch.
4. Press
INSERT m let its LED light.
5. Press the foo&witch to start hearing the track.
6. At the desired mcnnent, press the foovswitch again to punch the track into
xcold.
19