Standard Edition Specifications - Sunfire Series II User Manual

Standard Edition Specifications

Power output
325 watts continuous, per channel,
both channels driven into eight ohms,
from 20Hz-20kHz with no more than
0.5% T.H.D.
Power at clipping, minimum:
650 watts per channel into four ohms.
1300 watts per channel into two ohms
(time limited basis).
Hum and Noise
-100 dB, A-Weighted
Maximum output current
80 amperes peak to peak per channel
Maximum output voltage
51 Vrms
Output impedance
Voltage source: Approximately zero ohms
Current source: Approximately one ohm
Input impedance, RCA inputs
30kΩ
Input sensitivity for rated output
Unbalanced: 1.8 Vrms
Balanced: 1.8 Vrms
Input impedance, XLR inputs
24kΩ, each leg balanced to ground
Female XLR
Pin 1 is ground
Pin 2 is negative (cold)
Pin 3 is positive (hot)
Power Consumption
45W At idle
150W Typical (1/8th power)
1800W Absolute Max (Fuse Limit)
Dimensions
19.0 inches wide
6.5 inches high (including feet)
15.75 inches deep
Weight
37 lbs
Finish
Brushed aluminum and black anodize
© 2001 Sunfire Corporation.
All rights reserved. Sunfire Corporation
reserves the right to improve its products at
any time. Therefore, specifications are subject
to change without notice.
Manual part number : 913-042-00 Rev A
Standard Edition Specifications
User's Manual
9