Connecting An S-Video Device (Good Connection); Connecting A Vcr - Dynex DX-26LD150A11 User Manual

12
DX-26LD150A11/DX-32LD150A11
2 Connect one end of a 75-ohm, coaxial cable to the ANT/CABLE
IN jack on the back of the TV/DVD combo, then connect the other
end of the cable to the antenna, cable TV or satellite TV box jack.
Back of TV/DVD
combo
Antenna, cable TV, RF coaxial cable (75 ohm)
or satellite TV box
jack
Notes:
• We recommend using a 75-Ohm, coaxial cable to reduce interference
and noise that may be caused by radio wave transmissions.
• Do not bundle the coaxial cable with the power cord or any other
cables.
• If you are using an antenna and reception is not good, contact a
service technician to adjust the antenna.
Connecting an S-Video device (good
connection)
To connect an S-Video device:
1 Make sure that your TV/DVD combo's power cord is unplugged
and the S-Video device is turned off.
2 Connect an S-Video cable to the S-VIDEO OUT jack on the
S-Video device.
Back of TV/DVD
combo
S-Video device
3 Connect the other end of the cable to the AV INPUT S-VIDEO
jack on the back of your TV/DVD combo.
4 Connect an audio cable to the AV AUDIO OUT jacks on the
S-Video device.
5 Connect the other end of the audio cable to the AV INPUT (L/R
AUDIO) jacks on the back of your TV/DVD combo.
To play from the device:
1 Turn on your TV/DVD combo, then press INPUT. The Input Source
menu opens.
2 Press INPUT repeatedly or press or to select S-Video, then
press OK/ENTER.
ANT/CABLE IN
jack
S-Video cable
Audio cable
3 Turn on the S-Video device, and set it to the correct output mode.
See the S-Video device's user guide for more information.

Connecting a VCR

Note: If the VCR has an HDMI jack (best), component jacks (better), or an
S-Video jack (good), connect the VCR using the best available
connection.
To connect a VCR:
1 Make sure that your TV/DVD combo's power cord is unplugged
and the VCR is turned off.
2 Connect one end of a standard AV cable (not included) into the
AV INPUT VIDEO jack on the back of the TV/DVD combo, then
connect the other end of the cable to the AV OUT VIDEO jack on
the VCR.
-OR-
For a better picture, you can connect an S-Video cable to the
S-VIDEO OUT jack on the VCR and the S-VIDEO jack on your
TV/DVD combo. See "Connecting an S-Video device (good
connection) on page 12.
Back of TV/DVD
combo
Note: Cables are often
color-coded to connectors.
Connect yellow to yellow,
red to red, and white to
white.
3 Connect the audio connectors of the AV cable (the red and white
connectors) to the AV OUT AUDIO jacks of the VCR, then connect
them to the AV INPUT (L/R AUDIO) jacks on the back of your
TV/DVD combo.
To play from the VCR:
1 Turn on your TV/DVD combo, then press INPUT. The Input Source
menu opens.
2 Press INPUT repeatedly or press or to select S-Video or AV,
then press OK/ENTER.
3 Turn on the VCR, insert a videotape, then press PLAY on the VCR.
Making connections
AV cable
Back of VCR