On And Off Switching Functions Of The Edge Cutter By Classes 272-640142 And -740142 - Duerkopp Adler 271 Installation Instructions Manual

13. On and Off Switching Functions of the Edge Cutter
by Classes 272 - 640142 and - 740142
Motor type
Flip-Flop
Mode
On after
a number
of stitches
Off after
a number
of stitches
On - Off
manually
via keys
Off after
thread trimming
On - Off
with motor run signal
via pedal
In order to conduct the functions described below with the
272 - 640142 it must be equipped with the optional
equipment Z 124401. The optional equipment consists of
the electro-pneumatic operation for the edge cutter.
The various on and off switching ffunctions can be
entered with the appropriate parameter no.s at the control
panel.
For the necessary access to the service level see
Section 11.2 a) Efka Modular or b) Quick Digital.
Efka Modular
Parameter 190
Flip-Flop 6
Parameter 192
Set number of stitches
(max.254)
Parameter 193
Set number of stitches
(max.254)
Parameter 192 at 0
Parameter 193 at 0
Parameter 194 at Off
Parameter 194 at On
Parameter 190
Flip-Flop 3
Quick Digital
Parameter 510
Flip-Flop 6
Parameter 551
Set number of stitches
(max.254)
Parameter 552
Set number of stitches
(max.254)
Parameter 552 at 0
Parameter 551 at 0
Parameter 504 at 1
Parameter 504 at 2
Parameter 510
Flip-Flop 3
25