Positioning Drive With External Control Panel - Duerkopp Adler 271 Installation Instructions Manual

11.2 Positioning Drive with External Control Panel

20
Before commissioning with Efka only the position 0 and
with Quick only the reference position are to be entered.
These are the base points for all machine positions.
This initial position corresponds to slot D on the
adjustment disk = Needle tip in the needle plate.
When fastening the Efka synchronizer please observe
Section 6.
All machine positionsehave been programmed at the
factory.
Small mechanical adjustments must be made on the
synchronizer. Its hood cannot be removed.
The machine positions are registered by the synchronizer
in steps (increments) and shown in the display. A
complete revolution is divided with Efka into 510 and with
Quick into 480 steps.
a) Efka Modular
To enter the position 0 one proceeds as follows:
1. Hold key P down.
2 Turn on main switch. The display shows code
no. C-0000.
3. To access "Service Level 1" enter Efka code
no. 1907 with the keys 1....0.
4. Press key E. The display shows parameter no. F 100.
5. With the keys 1...0 enter parameter no. 170.
Key E drücken. - Service Routine 1 (Sr1) appears.
Key F drücken. - Position 0 appears.
6. Turn the handwheel one complete revolution in the
machinen direction of rotation and arrest in position D
with the enclosed timing pin.
This is "Position 0", that is, the dependent base point
for all machine positions set at the factory.
7. Press key P twice.
Check the mahine positions F and C.
This completes the setting.