Wiring Diagram; Replacing Fuse - Dual AXXERA XDMA7800 Installation & Owner's Manual

XDMA7800
RCA Preamp Output
Connections
SUBWOOFER
REAR
FRONT
Steering Wheel Interface Input
3.5mm Bluetooth Microphone Input
Connect the included
Bluetooth microphone.
BLUE Remote Turn-On
Connect to amplifier or power
antenna. Insulate wire if not used.
BLACK Ground
Connect to the vehicle
chassis ground.
RED Accessory
Connect to an existing ignition
circuit or switched 12 volt source.
YELLOW Memory
Connect to the battery
circuit or constant 12 volt source.
Right Front Right Rear
Gray/Black (-) Violet/Black (-)
Gray (+) Violet (+)
Left Front Left Rear
White/Black (-) Green/Black (-)
White (+) Green (+)
FRONT REAR SUB/W
L-CH
R-CH
REMOTE IN
PAC SWI-PS connection
(sold separately)
3

Wiring Diagram

BLACK Female USB Input
Rear USB Connection
BLUE 10-pin Female Mini-DIN
HDM90 Connection (sold separately)
Antenna
Optional USB Extension Cable
Connector
Bluetooth Microphone
(must be connected for Bluetooth functionality)
FUSE
When replacing the fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XDMA7800 uses one
10 amp ATM fuse located
beside the wiring connector.
(Included)