Changing The Needle; Replacing The Bulb - White SPEEDYLOCK 1500 Instruction Manual

CHANGiNG THE NEEDLE
Turn the power switch to "OFF' before changing
the
Hexagon wrench key
needles.
Do not use any needle which is bent or blunt.
l.Turn the handwheel toward you until the needles are
fully raised.
2.Open the front cover and lower the presser foot.
3. Using the hexagon wrench key from the accessory
box, loosen the needle clamp screws and remove the
needles. Upper left screw for left needle and lower
right screw for right needle.
4.lnsert the new needle with the flat side to the back into
the needle clamp, making sure it
is
inserted as far up
as possible. Tighten the needle clamp screw firmly.
When the needles are set correctly, the left needle is
slightly higher than the right one.
Flat side to the back
If needles are not correctly inserted, skipped stitches
will result.
This machine is equipped with needle systems H.A1
(Needle are household type).
Machine front
rREPLAcING THE BULB
I
Turn the power switch to "OFF' before replacing the bulb.
1 Take the hole cap off by needle.
2. Loosen the screw until it is taken apart.
3. Pull the lamp cover off from the low
part.
4.Push and
twist
and then remove the old bulb.
5.lnsert the new bulb and
twist
to its position.
Important
This machine is designed to ues 12 voltage 6 watt
bulb.
The bulb is available from your local dealer.
Needle
(Use HA'l)
—
11
—