TYAN S7010 User Manual page 67

3.2.12 Remote Access Configuration Sub-Menu
You can use this screen to view the Remote Access Configuration Menu. This
feature allows access to the Server remotely via serial port. Use the up and down
arrow (/) keys to select an item. Use the Plus and Minus (+/-) keys to change
the value of the selected option. The settings are described on the following pages.
Main
Configure Remote Access type and parameters
Remote Access
Serial Port Number
Base Address, IRQ
Serial Port Mode
Flow Control
Redirection After BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
Sredir Memory Display Delay
Feature
Configure Remote Access type and parameters
Remote Access
NOTE: The items listed below will appear when Remote Access is set to [Enabled].
Serial Port Number
Base Address, IRQ
Serial Port Mode
Flow Control
BIOS Setup Utility
Advanced PCI/PnP
Disabled
Enabled
Read only
115200 8,n,1
57600 8,n,1
38400 8, n, 1
19200 8,n,1
9600 8,n,1
Hardware
Software
http://www.tyan.com
Boot Security
[Disabled]
[COM1]
[3F8h, 4]
[38400 8, n, 1]
[None]
[Always]
[ANSI]
[Enabled]
[No Delay]
Option
Enables remote access to system
through serial port.
Select Serial Port for console
COM1
redirection. Make sure the selected
port is enabled.
COM2
Select Serial Port settings.
None
Select Flow Control for console
redirection.
67
Chipset Exit
Select remote access
type.
← → Select Screen
↑↓ Select Item
+ - Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Description