Table of Contents
Advertisement
3.8 – BIOS Security Menu
The system can be configured so that all users must enter a password every
time the system boots or when BIOS Setup is entered, using either the
Supervisor password or User password. The Supervisor and User passwords
activate two different levels of password security. If you select password
support, you are prompted for a one to six character password. Type the
password on the keyboard. The password does not appear on the screen when
typed. Make sure you write it down. If you forget it, you must clear CMOS and
reconfigure.
Main
Advanced
Security Settings
Supervisor Password : Not Installed
User Password
Change Supervisor Password
Change User Password
Boot Sector Virus Protection
Feature
Security Settings
Supervisor Password:
User Password:
Change Supervisor
Password
Change User Password
Boot Sector Virus Protection
BIOS Setup Utility
PCI/PnP
Boot
: Not Installed
[Disabled]
Option
Not Installed
Installed
Not Installed
Installed
Disabled
Enabled
http://www.tyan.com
Security
Install or change the
password.
← → Select Screen
↑↓ Select Item
+/-
F1
F10 Save and Exit
ESC Exit
Description
If the password has been set,
Installed displays. If no password
is set, Not Installed displays.
If the password has been set,
Installed displays. If no password
is set, Not Installed displays.
Selects this option to change or
install Supervisor Password.
Selects this option to change or
install User Password.
When it is set to [Enabled], BIOS
will issue a virus warning
message and beep if a write to
the boot sector or the partition
table of the HDD is attempted.
69
Chipset
Exit
Change Option
General Help
Advertisement
Table of Contents
