Lenovo ThinkCentre M70e Hardware Maintenance Manual page 63
Machine types: 0804, 0806, 0809, 0810, 0811, 0821, 0822, 0823,0825, 0827, 0828, 0829, 0830, 0832, 0833, 0835,0837, 0842, 0843, 0844, 0845, 0846, 0847, 0848,0849, 0851, and 4089
Hide thumbs
Also See for ThinkCentre M70e:
- (90 pages) ,
- Guida per l'utente (88 pages) ,
- Ghidul utilizatorului (88 pages)
Table of Contents
Advertisement
Diagnostic Error Code
030-196-XXX SCSI interface test halt, error threshold
exceeded
030-197-XXX SCSI interface test warning
030-198-XXX SCSI interface test aborted
030-199-XXX SCSI interface test failed, cause unknown
035-000-XXX RAID interface Test Passed
035-0XX-XXX RAID interface Failure
035-195-XXX RAID interface Test aborted by user
035-196-XXX RAID interface test halt, error threshold
exceeded
035-197-XXX RAID interface test warning
035-198-XXX RAID interface test aborted
035-199-XXX RAID interface test failed, cause unknown
071-000-XXX Audio port Interface Test Passed
FRU/Action
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Go to "Undetermined problems" on page 65
1. Go to "Undetermined problems" on page 65
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Replace component under function test
No action
1. RAID signal cable
2. RAID device
3. RAID adapter card, if installed
4. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Go to "Undetermined problems" on page 65
1. See "Undetermined problems" on page 65
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Replace component under function test
No action
Chapter 7
.
Symptom-to-FRU index
55
- Quick Links:
- For Machine Types: 0804, 0809, 0811,...
Hide quick links:
Advertisement
Table of Contents
