Lenovo ThinkCentre M70e Hardware Maintenance Manual page 60
Machine types: 0804, 0806, 0809, 0810, 0811, 0821, 0822, 0823,0825, 0827, 0828, 0829, 0830, 0832, 0833, 0835,0837, 0842, 0843, 0844, 0845, 0846, 0847, 0848,0849, 0851, and 4089
Hide thumbs
Also See for ThinkCentre M70e:
- (90 pages) ,
- Guida per l'utente (88 pages) ,
- Ghidul utilizatorului (88 pages)
Table of Contents
Advertisement
Diagnostic Error Code
015-196-XXX USB port test halt, error threshold exceeded
015-197-XXX USB port test warning
015-198-XXX USB port test aborted
015-199-XXX USB port test failed, cause unknown
018-000-XXX PCI Card Test Passed
018-0XX-XXX PCI Card Failure
018-195-XXX PCI Card Test aborted by user
018-196-XXX PCI Card test halt, error threshold exceeded
018-197-XXX PCI Card test warning
018-198-XXX PCI Card test aborted
018-199-XXX PCI Card test failed, cause unknown
52
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Go to "Undetermined problems" on page 65
1. Go to "Undetermined problems" on page 65
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Replace component under function test
No action
1. Riser card, if installed
2. System board
1. PCI card
2. Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Go to "Undetermined problems" on page 65
1. Go to "Undetermined problems" on page 65
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Replace component under function test
- Quick Links:
- For Machine Types: 0804, 0809, 0811,...
Hide quick links:
Advertisement
Table of Contents
