Removing And Reinstalling The Front Bezel - Lenovo ThinkCentre M70e Hardware Maintenance Manual

3. Disconnect the power cord, Input/Output (I/O) cables, and all other cables that are connected to the
computer.
4. Remove any locking device that secures the computer cover, such as an integrated cable lock or
a padlock.
5. Remove the two screws that secure the computer cover and slide the computer cover to the rear to
remove it.
Figure 40. Removing the computer cover

Removing and reinstalling the front bezel

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 101.
3. Remove the front bezel by releasing the three plastic tabs on the top of the front bezel and pivoting
the front bezel outward to remove it from the computer. Carefully lay the front bezel aside without
disconnecting the power switch and light-emitting diode (LED) assembly cable.
102
ThinkCentre Hardware Maintenance Manual