Sansui HDLCDVD320 Owner's Manual page 63

Connections to other equipment
To connect the TV/DVD to a camcorder, or a TV Game
To playback from a camcorder, connect the camcorder to the unit as shown.
This unit can also be used as a display device for many video games. However, due to the wide variety of
signals generated by these devices and subsequent hook-up variations required, they have not all been
included in the suggested connection diagrams. You'll need to consult each component's Owner's Manual for
additional information.
Rear of the unit
To connect the TV/DVD to a PC (Personal Computer)
Before you connect this TV/DVD to your PC, change the adjustment of your PC's Resolution and Refresh rate
(60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the
VGA connector PC MONITOR on the back of the TV/DVD. Attach the connectors firmly with the screws on the
plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia
computer and to the AUDIO connector of the PC/HDMI AUDIO IN jacks of the TV/DVD.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV/DVD can operate as the computer monitor.
Left side of the unit
To PC IN
PC/HDMI
AUDIO
IN jacks
NOTES:
•
The on-screen displays will have a different appearance in PC mode than in TV mode.
•
When you select WXGA or WVGA mode, see the WXGA INPUT to ON in the PC PICTURE menu (see page
38).
•
If there is no video signal from the PC when the unit is in PC mode, "NO SIGNAL" will appear on the TV-
screen.
To AUDIO/VIDEO IN 1 (or 2)
VGA cable (not supplied)
Audio cord (not supplied)
To Audio/Video OUT
Audio/Video cord (not supplied)
Monitor Display modes
MODE
VGA
VGA
WVGA
SVGA
XGA
WXGA
WXGA
To return to normal mode
Press INPUT SELECT again.
(continued)
or
Resolution Refresh rate
640x480 60Hz
720x400 70Hz
848x480 60Hz
800x600 60Hz
1024x768 60Hz
1280x768 60Hz
1280x720 60Hz
63