Installing The Optional Cinewide/Autoscope Lens Mount - Runco VideoXtreme VX-3000 Operation Manual

Installation
3.5
Installing the Optional
CineWide/AutoScope
Lens Mount
If you are installing a standard (non-CineWide) VX-3000i, VX-3000d or VX-3000 Ultra, skip
this step and proceed with Mounting the VX-3000 (page 36).
If you are installing a CineWide projector equipped with a prismatic
(Whitney) anamorphic lens, proceed with Installing the Fixed CineWide
Base Plate (Prismatic Lens) (page 31).
If you are installing a CineWide projector equipped with a
cylindrical (Rainier II or McKinley) anamorphic lens, proceed
with Installing the Fixed CineWide Base Plate (Cylindrical
Lens) (page 33).
If you are installing a VX-3000i/CineWide with AutoScope, VX-3000d/CineWide with
AutoScope or VX-3000 Ultra/CineWide with AutoScope, proceed as follows to install the
AutoScope lens motor.
1. Do not install the CineWide lens yet, only the fixed CineWide
Note
2. Some components shipped with your projector may differ slightly
base plate or AutoScope lens motor. You will install the CineWide
lens after you install the projector and adjust the primary lens.
from what is shown in these instructions.
26 VX-3000 Installation/Operation Manual