Panasonic Viera WT50A series Operating Instructions Manual page 51

Set all channels automatically [Auto Tuning]
Automatically retune all channels received in the area.
1
Start Auto Tuning
Example: Digital TV
Digital TV Auto Tuning
All digital TV tuning data will be erased
●
All the previous tuning settings are erased.
●
When the operation is completed, the channel at the lowest position will be displayed.
●
Search begins in the order from the lower channels to the higher channels.
●
If tuning has not been done completely
Set Digital TV channel manually [Manual Tuning]
Normally use [Auto Tuning] or [Update Channel List] to retune Digital TV channels.
If tuning has not been done completely or for adjusting the direction of the aerial or dish, use this function.
● All channels found will be added to the Channel List.
Digital TV Manual Tuning
Physical Channel
Signal Quality
Signal Strength
No. Channel Name
Digital TV: 0
Set Analogue TV channel manually [Manual Tuning]
Set Analogue TV channel manually after Auto Tuning.
●
If a VCR is connected only with the RF cable, select channel position [0].
Analogue TV Manual Tuning
0
Manual Tuning
1
Select the channel position
m
s
3
Search
[Manual Tuning] (see below)
[CH21] 474.00 MHz
0 10
0 10
Type New
CH 57
0 75
Store
2
Settings are made automatically
Example: Digital TV
Digital TV Auto Tuning
Scan CH 6
This will take about 3 minutes.
RF Ch Channel Name
32 TV Fin land Digital TV
32 Boxer Navigator Digital TV
32 SVT HD Digital TV
Digital TV: 4
Searching
select physical channel
select offset
start tuning
2
Select the channel
4
Select [Store]
select
store
69
Type Quality
9
9
9
51