Saving A Wav File - Fostex VF16 Supplement Owner's Manual

Saving a WAV file

In the following description, we assume that an operation-confirmed external SCSI CD-R/RW drive is connected
to the VF-16 SCSI terminal and a blank CD-R/RW disc is set.
Press the [SETUP] key.
1
The display shows the screen for selecting the SETUP
menu.
Select "Save PGM" SETUP menu by rotating the [JOG]
2
dial and press the [ENTER/YES] key.
The display shows the screen for selecting a device to
save data, where "SCSI" flashes.
While "SCSI" is flashing, press the [ENTER/YES] key.
3
The display shows the screen for selecting a save mode,
where "BkUp (backup)" flashes.
Flashing
While "BkUp" is flashing, press the [ENTER/YES] key.
4
The display shows the screen for selecting a backup
mode, where "WAV" flashes.
While "WAV" is flashing, press the [ENTER/YES] key.
5
The display shows the screen for selecting On or Off
of the Clipboard Export function, where "Off" flashes.
You can turn On and Off the function by pressing the
[REWIND] or [F FWD] key.
Flashing
If you would like to save all data from ABS0 to REC
END, leave the Clipboard Export function setting to
"Off" and go on to the next step.
VF-16 Owner's Manual V3.1 Supplement
The "Clipboard Export function" allows to save a
selected area of data between the Clipboard In and
Out points which are normally set when executing
the Copy-Paste or Move-Paste editing function.
Therefore, if you want to save only a specific area
of data, you need to register the Clipboard In and
Out points prior to the save operation.
For registering the Clipboard In and Out points,
see "Locating a mark point using a Memory Key" in
"Chapter 2 Basic Recording and Playback".
Flashing
< CAUTION >
If you save all data from " ABS 0 " to " REC END ", set
the " Clipboard Export function " to " Off ".
While "Off" is flashing, press the [ENTER/YES] key.
6
The display shows the screen for selecting a program
to be saved. The program number currently selected
flashes, while the data size of the program is shown in
"MB" unit.
Flashing
Select a program to be saved by the [JOG] dial and
7
press the [ENTER/YES] key.
The display shows the screen for selecting a track to
be saved, where "All Track" flashes.
Flashing
Flashing
In the above display condition, by rotating the [JOG]
dial (or press the [F FWD] key), you can select "From **
To **" (where the left field initially flashes) instead of
"All Track".
If you would like to save all track data (1 through 24),
select "All Track".
If you would like to save specific track (s), select "From
** To **". In this case the display changes to the following
screen.
Flashing
11
< About Clipboard Export function >