Chapter 1
Basic Operations
The following steps show how to change a
setting in the machine. In this example the
Paper Type setting is changed from
Plain Paper to Inkjet Paper.
a
Press Menu.
b
Press a or b to choose
General Setup.
MENU
Ink
General Setup
Print Reports
Press OK.
c
Press a or b to choose Paper Type.
Press OK.
d
Press a or b to choose Inkjet Paper.
Press OK.
You can see the current setting on the
LCD:
General Setup
Paper Type
Inkjet Paper
Paper Size
LCD Settings
e
Press Stop/Exit.
8
1
Select
OK
Status LED indications
The Status LED (light emitting diode) is a light
that shows the status of the machine, as
shown in the table.
LED
DCP status
Ready
Off
Cover open
Red
Cannot Print
Paper error
Other
messages
Description
The DCP is ready for
use.
The cover is open. Close
the cover. (See Error
and Maintenance
messages on page 35.)
Replace the ink cartridge
with a new one. (See
Replacing the ink
cartridges on page 32.)
Put paper in the tray or
clear the paper jam.
Check the LCD
message. (See Error
and Maintenance
messages on page 35.)
Check the LCD
message. (See Error
and Maintenance
messages on page 35.)
1