Controls; Installation - Saeco D.A. 7P Instructions For Installation And Use Manual

4 - CONTROLS

• Main swicth: placed on the machine rear side, below on the right.
• Selection panel: consisting of 7 selection buttons (11) which correspond to the same number of
beverages marked as A-B-C-D-E-F-G.
• Display (16): displays the inserted coln value.
• Green LEDS (12) next to the selection buttons: they will illuminate when beverages are available (once
the user has inserted coins for a corresponding or higher amount than the one established).
N.B. If the unit has been programmed to provide selections at no charge the green LEDS are always
illuminated.
• Red LEDS (13) next to the selection buttons: They will illuminate when the selected beverage is out.
• Green LED (14) "READY FOR USE": the machine is ready for normal operation.
• Red LED (15) "WATER EMPTY": indicates unit is out of water.
• Coin return button (18): Press to return the coins jammed inside the coin box.
• Stirrer dispenser button (19): Press button to dispense from the stirrer dispenser (20).

5 - INSTALLATION

5.1 Preliminary operations
• Check that the machine is inside its original packing, closed withs traps and that it has not been
tampered during transport.
• Remove the machine from the packing. We recommend to retain the packing material for future
transfers or transports.
• Set the machine on an adequate sized and perfectly horizontal top, and make sure it can tolerate either
the machine and the component weight.
• Attention: strong magnetic fields or electric machines generating strong noises and located next to the
equipment, could cause troubles to the machine electronic control.
5.2 Power connection
• Connect the machine to an adequate power supply (consult the data plate on the machine rear side).
• Ensure that the electric installation, where the machine has to be installed, is made according to the
current safety regulations.
5.3 Water connection (only for machines directly connected to the cold water line )
0
6
• Connect the machine to a drinking water system, where the
pressure is between 1.5 and 8 bars. For this operation, use
an adequate tube and connect it to the 3/4" Gas fitting,
protuding through the machine rear panel (Fig.A).
Fig. A
English