Auto Tuning - Panasonic Viera ET5A series Operating Instructions Manual

Auto Tuning

Search and store TV channels automatically.
●
These steps are not necessary if the setup has been completed by your local dealer.
● Please complete connections (p. 12 - 14) and settings (if necessary) of the connected equipment before starting Auto
Tuning. For details of settings for the connected equipment, read the manual of the equipment.
1
2
3
4
5
Plug the TV into mains socket and switch on
●
Takes a few seconds to be displayed.
● If the red LED shows on the TV, press the Standby On / Off switch on the
remote control.
Select your area
Select State / Territory
New South Wales / Australian Capital Territory
Victoria
Queensland
South Australia
Western Australia
Northern Territory
Tasmania
Select the mode to tune
TV Signal Selection
Digital TV
Analogue TV
Start Auto Tuning
Select [Start Auto Tuning]
TV Signal Selection
Digital TV
Analogue TV
Start Auto Tuning
●
Auto Tuning will start to search for TV channels and store them.
The stored channels and sorted channel order vary depending on the area,
broadcasting system and conditions of signal reception.
Auto Tuning
Digital TV Scan CH 6
Analogue TV Scan CH 0
This will take about 6 minutes.
RF Ch Channel Name Type
62 CBBC Channel Digital TV
62 BBC Radio Wales Digital TV
62 E4
Digital TV
62 Cartoon Nwk Digital TV
29
Analogue TV
33 Analogue TV
Digital TV: 4 Analogue TV: 2
Searching
Setup the network connection
Setup the network connection to enable the network service functions such as VIERA
Connect, etc. (p. 18, 70).
● Please note that this TV does not support wireless public access points.
●
Ensure the network connections (p. 14) and network environment are completed
before starting setup.
Select the network type
Network Setup
Select Wired or Wireless
Wired Wireless Set later
select
set
select
tune / skip tuning
: tune (search for the available channels)
: skip tuning
select
access
69
75
Quality
10
10
10
10
-
-
[Wired] "Wired connection" (p. 14)
[Wireless] "Wireless connection"
(p. 14)
select
access
●
To setup later on or skip this step
Select [Set later] or
15