Loading From An Audio Cd - Fostex VF08 Supplement Owner's Manual

You can load a desired song to the VF08 from an audio CD you created by recording on a CD-RW/CD-R disc.
When a desired song is loaded, the VF08 automatically creates a new program on the current drive, and the
song are recorded on tracks 1 and 2 of the program. Loading data from an audio CD is operated via the "Load
PGM" menu in the Setup mode, which is the same way as loading backup data.
INPUT A PHONES
INPUT B
BAL
BAL
GUITAR GUITAR
LINE MIC LINE MIC MIN MAX
UNBAL TRIM UNBAL TRIM
CH ON/OFF CH ON/OFF
PEAK PEAK
TRACK STATUS RED REC GREEN
TRACK STATUS / TRACK SEL
1 2 3 4 5
+6 +6
+6 +6 +6
0 0 0 0 0
-10 -10 -10 -10 -10
-20 -20 -20 -20 -20
-30 -30 -30 -30 -30
-40 -40 -40 -40 -40
- -
- - -
<Important note for copyright>
You can also load a material from a commercially
available audio CD in the same manner, however,
never use a material for which a copyright is re-
served for a commercial purpose.
Any unauthorized use will constitute infringement
of such copyright and will render the infringer li-
able to an action at low.
In the following description, we assume that a CD-
RW drive is connected to the SCSI port of the Model
8340 installed in the VF08 and an audio CD created
is prepared.
<Note>
Do not carry out any VF08 key operation until the access
process to the CD-RW/CD-R disc is completed.
1. After turning on the power of both the VF08 and a
connected CD-RW drive, load a recorded audio CD disc
to the CD-RW drive.
2. Press the [SETUP] key to enter the Setup mode.
3. Use the [JOG] dial to select (highlight) the "Load PGM"
menu and press the [ENTER/YES] key.
The display shows the screen for selecting the device from
which the data is loaded. "SCSI" flashes.
4. Press the [ENTER/YES] key while "SCSI" flashes.

Loading from an audio CD

VF08
ST OUT FOOT SW
L R
MIX PARAMETER
TRACK
EDIT SCENE SCENE SEQ.
DIGITAL MULTITRACKER
PGM FADER MAP
PAN EQ EFFECT
ON/OFF
ACCESS
BOUNCE MODE 2TRK MODE
MASTERING TRAINING
PHANTOM
F1 F2 F3
PLAY OFF MUTE
STATUS
/SEL
JOG SHUTTLE
6 7/8 2TRK MASTER
CURSOR
EXIT
/NO
EJECT
+6 +6 +6
ENTER
/YES
0 0 0
TIMEBASE UNDO
SETUP SEL /REDO
-10 -10 -10 F1 F2 F3 SHIFT
WAVE FORM LOCATE
AUTO VARI
PUNCH LOOP PITCH SCRUB
-20 -20 -20
-30 -30 -30
EDIT EDIT EDIT MARK DELETE
-40 -40 -40
RECORD STOP PLAY REWIND F FWD
- - -
LOCATE ABS 0
LOCATE REC END
flashing
CD-RW/CD-R disc (or commercially available audio CD)
After showing the model name of the connected CD-RW
drive, the display shows the screen for selecting the load
mode, in which "BkUp" flashes.
To carry out loading a song from an audio CD, select
"CD-DA".
flashing
5. Use the [JOG] dial (or [CURSOR] < > key) to select
(highlight) "CD-DA", then press the [ENTER/YES] key.
A warning message for copyright appears.
You can scrolls the message to read all message by
rotating the [JOG] dial.
<Warning message>
The warning message for copyright shown on
the screen is as follows.
Warning!
You are responsible for use of this digital de-
vice. Be sure to abide by the copyright condi-
tions of the source material.
Press "Enter/Yes" key if you agree with the
above.
17