Installation; Gas Connection - Zanussi ZGF 780 IT Instruction Booklet

Installation

IMPOR T T T T T ANT IMPOR IMPOR ANT ANT
IMPOR IMPOR ANT ANT
Any gas installation must be carried out by a GAS SAFE REGISTER
installer.
Please, ensure that, once the hob is installed, it is easily accessible for the
engineer in the event of a breakdown.
The manufacturer will not accept liability, should the above instructions or
any of the other safety instructions incorporated in this instruction booklet
be ignored.
On the end of the shaft,
which includes the G 1/2"
threaded elbow, adjustment
is fixed so that the washer
is fitted between the
components as shown in
the diagram. Screw the
parts together without using
excessive force.

Gas Connection

Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel
or copper.
The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread).
When the final connection has been made, it is essential that a thorough leak test is
carried out on the hob and installation.
Ensure that the main connection pipe does not exert any strain on the hob.
It is important to install the elbow correctly, with the shoulder on the
end of the thread, fitted to the hob connecting pipe.
Failure to ensure the correct assembly will cause leakage of gas.
Check to be sure that all connections to the unit are completely gas-tight;
use a soap solution to do this, never a flame.
18
A) End of shaft with nut
B) Washer
C) Elbow