Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZGF 789
Summary of Contents for Zanussi ZGF 789
- Page 1 GAS HOB ZGF 789 INSTRUCTION BOOKLET...
-
Page 2: Important Safety Information
Important Safety Information You MUST read these warnings carefully before installing or using the appliance. Installation Ensure the control knobs are in the ‘OFF’ This appliance must be installed, regulated and position when not in use. set for operation by qualified personnel with proper authorization from the Ministry of Labour, When using other electrical appliances, ensure according to the manufacturer’s instructions... -
Page 3: Table Of Contents
Contents For the User Guide to Use the instructions Important Safety Information Page Description of the Hob Page The following symbols will be found in the text Operation Page to guide you throughout the Instructions: Maintenance and Cleaning Page Something Not Working? Page Safety Instructions For the Installer... -
Page 4: Operation
Operation INSTALLATION Any gas installation must be carried out by If you use a saucepan which is smaller qualified personnel, and in accordance with than the recommended size, the flame will existing rules and regulations. spread beyond the bottom of the vessel, The relevant instructions are to be found in the causing the handle to overheat. -
Page 5: Maintenance And Cleaning
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. -
Page 6: Something Not Working
Something Not Working? If the appliance is not working correctly, please carry out the following checks before contacting your local Service Centre. SYMPTOM SOLUTION There is no spark when lighting the gas Check that the unit is plugged in and the electrical supply is switched on Check the mains fuse has not blown Check the burner cap and crown have been... -
Page 7: Installation
Installation IMPORTANT This appliance must be installed by qualified personnel. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Gas Connection On the end of the shaft (A) , which includes the GJ 1/2"... -
Page 8: Building In
Building in Building over a kitchen unit with Building over a cupboard or oven drawer If the hob is built into a kitchen unit with an oven If the hob is to be installed above a cupboard or underneath, the recess must have the dimensions drawer it will be necessary to fit a heat resistant shown in diagrams 2 and 3, and should also incor- board below the base of the hob on the underside... -
Page 9: Fitting The Hob To The Worktop
Fitting the hob to the worktop Carry out the building in of the hob as follows: • put the seals supplied with the hob, on the edges of the cut out: place them at 8 mm from the front and rear edge and at 50 mm from the side edges, as shown in figure 6, taking care that the seals meet without overlapping;... -
Page 10: Electrical Connection
Electrical Commissioning connection Any electrical work required to install this When the hob has been fully installed it will be appliance should be carried out by a qualified necessary to check the minimum flame setting. electrician or competent person, in To do this, follow the procedure below.