Zanussi ZDF311 User Manual page 9

156999480en.qxp 3/2/2006
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
The dishwasher must
be switched off.
Switch on the
dishwasher by pressing
the On/Off button.
The End of
programme light might
flash 5 times, for
example. The flashing is
repeated every 5
seconds.
8:11 AM Pagina 9
Press and hold
simultaneously function
buttons 2 and 3 until the
lights of function
buttons 1, 2 and 3 start
flashing.
To change the level, The End of
press function button 1. programme light
Each time the button is indicates the new
pressed the level setting. (For the
increases. (Level 1 selection of the new
follows level 10). level see the chart).
Release the buttons and then press function button
1; the lights of function buttons 2 and 3 turn off while
function button 1 goes on flashing. At the same time
End of programme light starts to flash.
The number of flashes of the End of programme
light corresponds to the current level.
To memorise the
operation, switch off the
dishwasher by pressing
the On/Off button.
9