156999480en.qxp 3/2/2006 8:11 AM Pagina 3 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents.
156999480en.qxp 3/2/2006 8:11 AM Pagina 4 Never use the dishwasher if the electrical ● WARNING! supply cable and water hoses are damaged; For electrical and water connection carefully or if the control panel, work top or plinth area follow the instructions given in specific are damaged such that the inside of the paragraphs.
Page 5
156999480en.qxp 3/2/2006 8:11 AM Pagina 5 In addition to the dishwashing programme selection, the following functions can also be set with the help of these buttons. - the setting of the water softener, Function buttons - the cancelling of a programme in progress.
156999480en.qxp 3/2/2006 8:11 AM Pagina 6 IMPORTANT! It is possible to select a washing programme and the delay start also with the door slightly opened. In this case the start of the programme or the countdown will occur after the closure of the door.
156999480en.qxp 3/2/2006 8:11 AM Pagina 7 Before the first use When using separately special (dishwasher) salt, rinse aid and detergent: - set the water softener - add special salt - fill up with rinse aid When using tablets that integrate rinse aid and detergent: there is no need to fill up with rinse aid - set the water softener...
156999480en.qxp 3/2/2006 8:11 AM Pagina 8 Setting the water softener The dishwasher is equipped with a water IMPORTANT! softener designed to remove minerals and salts The water softener must be set in both ways: from the water supply, which would have a manually and electronically.
Page 9
156999480en.qxp 3/2/2006 8:11 AM Pagina 9 Setting the water softener electronically (see table) The water softener is factory set at position 5. The dishwasher must Press and hold Release the buttons and then press function button be switched off. simultaneously function 1;...
156999480en.qxp 3/2/2006 8:11 AM Pagina 10 Filling with dishwasher salt CAUTION! Use only special salt suitable for dishwashers Unscrew the cap. Only before filling with Using the funnel salt for the first time, provided, pour in the fill the salt container salt until the container is with water full.
156999480en.qxp 3/2/2006 8:11 AM Pagina 11 Filling with rinse aid Open the lid. Fill up with rinse aid. Clean up any rinse aid The maximum level for which overflows. Close filling is indicated by the lid and press until it locks.
156999480en.qxp 3/2/2006 8:11 AM Pagina 12 Loading cutlery and dishes The following items are not suitable for use When loading the dishwasher, make sure ● ● in the dishwasher: that you: - Remove all left over food and debris. - Cutlery with wooden, horn, china or mother-of-pearl handles - Soften remnants of burnt food in pans - Plastic items that are not heat resistant...
Page 13
156999480en.qxp 3/2/2006 8:11 AM Pagina 13 Load the lower basket. The two rows of prongs Arrange serving dishes and large lids around the on the lower basket can edge of the basket. be easily lowered to allow you to load pots, pans and bowls.
156999480en.qxp 3/2/2006 8:11 AM Pagina 14 Adjusting the height of the upper basket If washing very large Maximum height of the dishes in: plates you can load them upper basket lower basket in the lower basket after With upper basket raised 20 cm 31 cm moving the upper basket...
156999480en.qxp 3/2/2006 8:11 AM Pagina 15 Filling with detergent IMPORTANT! Only use detergents suitable for dishwashers. Observe the manufacturer’s dosing and storage recommendations. Open the lid. Observe the dosing Fill in the detergent in levels. compartment A. For programmes with When using detergent Close the lid.
156999480en.qxp 3/2/2006 8:11 AM Pagina 16 Cleaning and Care Cleaning the filters IMPORTANT! NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Remove filter A from the The dishwasher must Clean filters A, B and C Turn the handle about base of the washing be switched off...
156999480en.qxp 3/2/2006 8:11 AM Pagina 17 External cleaning Frost precautions Clean the external surfaces of the machine and Avoid placing the machine in a location where control panel with a damp soft cloth. If the temperature is below 0°C. If this is necessary use only neutral detergents.
156999480en.qxp 3/2/2006 8:11 AM Pagina 18 Something not working IMPORTANT! The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer. Open the door and carry out the following suggested corrective actions.
Page 19
156999480en.qxp 3/2/2006 8:11 AM Pagina 19 The wash results are not satisfactory The wrong washing programme has been selected. ● The dishes are not clean The dishes were arranged in such a way as to stop water reaching all parts ●...
156999480en.qxp 3/2/2006 8:11 AM Pagina 20 Technical data Dimensions Width 60 cm Height with worktop 85 cm Height without worktop 82 cm Depth. 61 cm Electrical connection Information on the electrical connection is given on the rating plate on Voltage - Overall power - Fuse the inner edge of the dishwasher’s door.
156999480en.qxp 3/2/2006 8:11 AM Pagina 21 Hints for Test Institutes Testing in accordance with EN 60704 must be Test in accordance with EN 50242 must be carried out with appliance fully loaded and carried out when the salt container and rinse using the test programme (see "Consumption aid dispenser have been filled with salt and values").
156999480en.qxp 3/2/2006 8:11 AM Pagina 22 CAUTION! If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. Drain hose Inlet hose Connect the inlet hose to a water tap with an...
156999480en.qxp 3/2/2006 8:11 AM Pagina 23 Electrical connection WARNING! WARNING! Safety standards require the appliance to be Multi-way plugs, connectors and extension earthed. The manufacturer accepts no liability cables must not be used. This could constitute for failure to observe the above safety a fire hazard through overheating.