Something Not Working - Zanussi ZDF311 User Manual

156999480en.qxp 3/2/2006

Something not working

IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
Fault code / malfunction
The dishwasher does not fill with
water.
- continuous flashing of the
light of the running programme
- 1 flash of the "End of
programme" light
The dishwasher will not drain.
- continuous flashing of the
light of the running programme
- 2 flashes of the "End of
programme" light
- continuous flashing of the
light of the running programme
- 3 flashes of the "End of
programme" light
The programme does not start.
Once these checks have been carried out; press the button of the programme that was running
before the intervention of the alarm. The programme will continue from the point at which it was
interrupted. If the malfunction or fault code reappears contact the Service Force Centre.
For other combinations of fault codes not described in the above chart, please contact your
Service Force Centre.
IMPORTANT!
When carrying out the suggested corrective
actions the appliance must be switched off.
18
8:11 AM Pagina 18
Possible cause
The water tap is blocked or furred
with limescale.
The water tap is turned off.
The filter (where present) in the .
threaded hose fitting at the water
inlet valve is blocked.
The water inlet hose has not been
correctly laid or it is bent or
squashed.
The sink spigot is blocked.
The water drain hose has not been
correctly laid or it is bent or
squashed.
Anti-flood device has activated.
The dishwasher door has not been
properly closed.
The main plug is not plugged in.
The fuse has blown in the household Replace the fuse.
fuse box.
Solution
Clean the water tap.
Turn the water tap on.
Clean the filter in the.
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain hose
connection.
Close the water tap and
contact your local Service
Force Centre.
Close the door
Insert the mains plug