Canon BJC-8200 Photo Service Manual page 63

BJC-8200
9. Waste Ink Full
Warning/Error
<Measure>
Visually check waste
ink absorber
Is the amount of
ink absorbed
exceeding
75%?
Yes
Replace waste
ink absorber
<Cause>
The calculated amount of waste ink absorbed is 100%
or 95% of the capacity of the waste ink absorber.
<Suspected parts>
• Check how much ink is absorbed in waste ink absorber.
(Determine absorption ratio of the waste ink absorber in %.)
See Figure 3-7 "A Guide to Determine the Amount of
Waste Ink Absorbed" on Page 3-11.
No
1. Set the waste amount
into EEPROM again
2. Replace logic board
• Reset the EEPROM waste ink counter.
(See Page 3-8)
4-9
Part 4: TROUBLESHOOTING
Waste ink absorber, logic board,
EEPROM
0% (Clear), 25%, 50%, and 75%
See Part 3: 2.1 Service Mode
Operations