Grease Application - Canon BJC-8200 Photo Service Manual

Part 2: MAINTENANCE

2.4 Grease Application

Apply greases at the points shown below.
Apply a thin film of grease using the flat brush. For the grease (EU-1) for the grease
pad, do not use a brush but apply directly. For printer disassembly and reassembly
procedures, refer to the parts catalog.
CAUTION
Cam Sliding Surface
Approx. 24 mg (Molykote PG-641 )
Eject Roller Gear Teeth (apply to all teeth evenly)
Approx. 60 mg (Molykote PG-641 )
LF Gear Teeth (apply to all teeth evenly)
Approx. 72 mg (Molykote PG-641 )
Feed Roller Sliding Surface
Approx. 24 mg (Molykote PG-641)
When applying greases, be careful to not get any on the wiper, cap, or
encoder film. If grease is applied to them, wipe them clean immediately.
Grease Pad
Approx. 35 mg (EU-1)
Feed Roller Gear Teeth
(apply to all teeth evenly)
Approx. 96 mg (Molykote PG-641)
Feed Roller Sliding Surface
Approx. 12 mg (Molykote PG-641)
Figure 2-8 Grease Points
Guide Shaft Sliding Surface
(apply the proper amount of grease so as not to drip)
Approx. 90 mg (EU-1)
Guide Frame Underside (apply
a thin coat of grease over the entire surface)
Approx. 48 mg (Molykote PG-641)
2-8
BJC-8200
Cam Sliding Surface
Approx. 24 mg
(Molykote PG-641 )
Paper Thickness Lever
Approx. 12 mg
(Molykote PG-641)