YOUR WARRANTY Here's how your warranty works: JBS Technologies warrants to the original customer, in the originally installed vehicle a limited lifetime warranty, providing the system was installed by an authorized dealer. Within 12 months of purchase, JBS Technologies will repair or replace, our option, any defective system at no charge. After 12 months from date of purchase, JBS Technologies will, at our option, repair or replace the system for a $20 shipping and handling fee.
OPERATING INSTRUCTIONS CONTENTS Deluxe 12I Trunk Release Output The remote car starter includes an optional output that can be used to do one of the following: Deluxe Remote Starter with Keyless Entry open the trunk, roll up the windows (optional module required), close the sun roof (optional module needed) etc.
SYSTEM FEATURES OPERATING INSTRUCTIONS Remote Starter Features Remote Programmable Remotely program your vehicle to automatically start when the Button #1: Remote starts your vehicle from up to a quarter Low Voltage Start battery voltage drops below 11 volts. mile. Button #2: Arm locks and disarm unlocks your power door Remote Programmable Remotely program your vehicle to run from 5 to 15 minutes.
U.S.A. The dependability and variety of features make Runtime Programming (Engine Off) Bulldog Security Security the leader in the industry. Press and hold Button #4 (Stop) for approximately 10 seconds. The parking lights will begin to flash, each flash represents 5 minutes with the maximum being 25 minutes, 5 flashes.
PRECAUTIONS PROGRAMMING INSTRUCTIONS Programming Tach Learn This system is designed to be used with fuel-injected and diesel Press and hold the brake, then press and hold Button #2 until the parking lights flash twice. vehicles with automatic transmissions only. Release Button #2. NOTE: The unit must be set to Tach Start first. Next, turn the ignition on. (If your vehicle is a diesel, wait for the glow plug to go out then proceed to the next step) Start SAFETY FIRST! the engine with the key then press and release Button #4.
MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only) Entering Programming Mode When installing a Bulldog Security remote starter on GM vehicles or Dodge Make sure your key is not in the ignition and the brake is pressed. The brake is to remain Dakotas built prior to 1996, you must: Use the diagram below to create pressed as long as you want to remain in programming mode.
ANTENNA PLACEMENT CONNECTING DOORLOCKS WHEN ADDING 5-PIN DOORLOCK HARNESS Antenna DOORLOCK ACTUATORS Antenna Wire DOOR #1 CENTRAL LOCKING SYSTEM Control Module Run the antenna 4-pin harness up the windshield pillar on the driver’s side and across the top of the windshield tucking the antenna harness inside the headliner, behind the rearview mirror.
CONNECTING DOORLOCKS INSTALLATION DIAGRAM “Type C” Reverse Polarity (5-pin harness) POWER GREEN/BLACK Unlock Out DOOR security.com bulldog www. LOCK 800-878-8007 GREEN/WHITE Unlock In MOTOR RED 12 V CONSTANT Standards With Comply Tested 12V(+) Security Bulldog M200 WHITE/BLACK ACCESSORY RED/BLACK +12V Constant RED 12 V CONSTANT 12V(+) BLUE/BLACK Lock Out...
TESTING DOORLOCKS CONNECTING THE 18-PIN HARNESS Testing Switch Wire and Motor Wires 8. GREEN/BLACK (+) Diesel Glow Plug Input (Optional) This wire is for diesel vehicles with a positive glow plug light wire to delay the for” Type C” Door Locks remote starter.
CONNECTING THE MAIN POWER, TESTING DOORLOCKS IGNITION AND ACCESSORY WIRES There are four basic types or door locks: 5. YELLOW/BLACK (+) Starter Crank Output This wire must attach to the vehicles ignition switch wire that shows 12 volts in “Type A” Door Lock Test (Most GMs and some Chryslers) the start/crank position only.