Gigabyte GA-P55A-UD6 User Manual page 119

For the Marvell 9128:
Turn off your computer and replace the failed hard drive with a new one. Please note to perform the rebuild,
you must enter the GSATA RAID Configuration menu in BIOS Setup.
Step 1:
After the system starts, enter the BIOS Setup program and go to Integrated Peripherals. Press <Enter> on
GSATA RAID Configuration to access the RAID configuration menu. Move the selection bar to the array to
be rebuilt (for example, VD 0: New_VD) and press <Enter> and then select Rebuild. Press <Enter> again.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Topology
HBA 0 : Marvell 0
Virtual Disks
VD 0: New_VD
PD 8: WDC WD800JD-22L
[Delete]
Free Physical Disks
[Rebuild]
PD 0: WDC WD800JD-22L
Help
Rebuilding with selected physical disk on this array.
ENTER: Operation F10: Exit/Save ESC: Return
Step 2:
The selection bar will move to the new drive. Press the <Space> key to select it and then press <Enter>.
When prompted to confirm, press <Y> to begin the rebuild or <N> to cancel.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Topology
HBA 0 : Marvell 0
Virtual Disks
VD 0: New_VD
PD 8: WDC WD800JD-22L
Free Physical Disks
* PD 0: WDC WD800JD-22L
Rebuild
Do you want to rebuild with selected physical disk on this vd?
Help
Use space bar to select the free disks to be used in the array.
ENTER: Operation SPACE: Select F10: Exit/Save ESC: Return
Information
ID :
Name :
Status :
Stripe Size :
RAID Mode :
Size :
BGA Status :
Number of PDs :
Numbers :
Information
ID :
Name :
Status :
Stripe Size :
RAID Mode :
Size :
BGA Status :
Number of PDs :
Numbers :
Yes No
- 119 -
0
New_VD
Degrade
64K
RAID1
75776MB
N/A
1
8
0
New_VD
Degrade
64K
RAID1
75776MB
N/A
1
8
Appendix