Rimage Professional 5400N User Manual page 14

Operate the Professional 3400 and 5400N System
Pause the System
You can pause the system to add discs to the carousel.
1. Open the front door. The operation pauses.
2. Close the front door. The operation resumes.
Load the Discs
You can load up to 50 discs in each input bin. Use the procedure below to
load discs in each bin.
Important! Place the discs with the recording side facing down.
Tip: Through the Rimage software, you may designate bins 1 through 3 as
input, output, reject, or a specific media type.
1. Open the front door.
2. Press the rotate carousel button to rotate the carousel and place a bin
in position to load discs.
3. Remove any completed discs from the bin.
4. Repeat steps 2 - 3 until the required bins are filled.
5. Close the front door.
Unload the Discs
1. Open the front door.
2. Press the rotate carousel button to rotate the carousel and place a bin
in position to remove discs.
3. Remove the discs from the bin.
4. Repeat steps 2 - 3 until the required bins are empty.
5. Close the front door.
2001431_C
Place a Disc on the Printer Tray
Use this procedure to manually place a disc on the printer tray.
1.
2.
3.
For more information visit rimage.com/support
Press the printer tray button on the control panel. The printer tray
opens.
Place the disc on the print pad with the printable surface facing up and
the stacking ring facing the print pad.
Important! To avoid scratching or damaging the recording surface of the
disc, the disc must not rest on the holding pins or the centering pin.
Press the printer tray button. The printer tray closes.
Holding Pins
11