Pair Devices - Nokia N70 User Manual

Tip! If you have searched for devices earlier, a list
of the devices that were found previously is shown
first. To start a new search, select
you switch off the device, the list is cleared.
Device icons:
—Computer;
—Headset;
To interrupt the search, press Stop. The device list
freezes.
3
Select the device with which you want to connect.
4
If the other device requires pairing before data can be
transmitted, a tone sounds, and you are asked to enter
a passcode. See 'Pair devices', p. 84.
5 When the connection has been established,
data is shown.
The Sent folder in
sent using Bluetooth connectivity.
Tip! When searching for devices, some devices may
show only the unique addresses (device addresses). To
find the unique address of your device, enter the code
*#2820# in the standby mode.

Pair devices

Glossary: Pairing means authentication. The users of
the two devices with Bluetooth technology should
agree on a common passcode, and use the same
84 Copyright © 2006 Nokia. All rights reserved.
More
—Phone; —Audio or video;
—Other.
Messaging does not store messages
passcode for both devices in order to pair them. Devices
that do not have a user interface have a factory-set
devices. If passcode.
In the Bluetooth
devices view (
Before pairing, create your own passcode (1—16 digits),
and agree with the owner of the other device to use the
same code. The passcode is used only once.
To pair with a device, select
Devices with wireless Bluetooth technology that are within
range start to appear on the display one by one. Select the
device, and enter the passcode. The same passcode must be
Sending entered on the other device as well. After pairing, the
device is saved to the paired devices view.
Paired devices are indicated by
Tip! To define a short name (nickname or alias) for a
paired device, scroll to the device, and select
Assign short name
name helps you to recognise a certain device during
device search or when a device requests a connection.
To set a device to be authorised or unauthorised, scroll to
a device, select
Set as authorised—Connections between your device and
this device can be made without your knowledge. No
separate acceptance or authorisation is needed. Use this
main view, press to open the paired
).
Options > New paired
in the device search.
in the paired devices view. This
Options and from the following:
device.
Options >