Table of Contents
Advertisement
Gas connections
• Before installation ensure that the local
distribution
conditions
pressure)
and
the
appliance are consistent.
• This appliance must be installed only in a
room with good ventilation.
• This appliance must not connected to a
chimney. It has to be installed and connected
in accordance with the rules in force. Special
attention should be paid to the applicable
disposal concerning ventilation.
• The adjacent furniture panels have to be heat
proof or protected by such material.
• The adjusting conditions of this appliance are
mentioned on the rating plate.
Connection to gas supply.
Check that the gas flow and the diameter of the
supply pipe is sufficient to supply all the
appliances of the installation.
• Check that all connections are tight.
• Install an accessible and visible gas tap to
isolate the appliance.
The
manufacturer
responsibility for possible damages resulting
from an installation which doesn't comply
with current legislation.
-
Installation of flues and ventilation for
gas
appliances
exceeding 60 kW (1
gases)
–
Part
installation
of
ventilation
appliances – BS 5440;
-
Gas
burning
appliances
Domestic cooking appliances burning
gas – BS 5386;
-
Specification
for
pressure gas pipe work of up to 20mm
(R1) in domestic premises (2
gas) – BS 6891;
-
Pipe threads for tubes and fittings where
pressure-tight joints are made on the
threads (metric dimensions) – BS 21:
1985;
-
Flexible hoses, end fittings and sockets
for gas burning appliances – BS 669;
-
Installation of domestic gas cooking
st
nd
appliances (1
, 2
BS 6172: 1990;
ADVICE FOR SAFETY
(gas
type
and
pre-setting
of
the
declines
any
of
rated
input
not
st
nd
rd
, 2
and 3
family
2
Specification
for
for
gas
–
Part
3
installation
of
low
nd
family
rd
and 3
family gases) –
19
Advertisement
Table of Contents
