Mazda Tribute Owner's Manual page 70

Driver Controls
1. Firmly press the two outer
Car2U system buttons for
1–2 seconds, then release.
2. Go to the garage to locate the
garage door opener motor and
its "learn" button. You may need
a ladder to reach the unit and
you may need to remove the
unit's cover or light lens to
locate the "learn" button. Press
the "learn" button, after which
you will have 10–30 seconds to
return to your vehicle and
complete the following steps. If
you cannot locate the "learn" button, refer to the Owner's Manual of
your garage door opener or call the toll-free Car2U system help line
at 1-866-57Car2U (1-866-572-2728).
3. Return to your vehicle. Press
and hold the Car2U system
button you would like to use to
control the garage door. You
may need to hold the button
from 5–20 seconds, during
which time the selected button
indicator light will blink slowly.
Immediately (within 1 second) release the button once the garage
door moves. When the button is released, the indicator light will
begin to blink rapidly until programming is complete.
4. Press and release the button again. The garage door should move,
confirming that programming is successful. If your garage door does
not operate, repeat the previous steps in this section.
After successful programming, you will be able to operate your Car2U
system by pressing the button you programmed to activate the opener.
68