M-Audio Delta Audiophile 2496 Manual page 20

hardware analog stereo pair to one of five stereo sources:
1. The default setting, "WavOut 1/2", connects ports OUT1 and OUT2 to your
music software or Windows multimedia applet. In other words, when music
software plays audio to the device named "WavOut 1/2 Delta-AP" it will be
routed directly to the Audiophile hardware analog output jacks.
2. The second option, "Monitor Mixer," connects ports OUT1 and OUT2 to the
outputs of the Audiophile 2496 monitor mixer. For more information of the
capabilities of the monitor mixer, please see the section "Monitor Mixer Page."
3. The third option, "S/PDIF In," connects ports OUT1 and OUT2 directly to the
hardware S/PDIF input of the Audiophile card. The left channel of the S/PDIF
In is routed to OUT1 and the right channel of the S/PDIF In is routed to OUT2.
4. The fourth option, "S/PDIF In (L/R Rev.)," functions identically to the third
option, except that the left and right channels are swapped. Therefore in this
mode, the left channel of the S/PDIF In is routed to OUT2 and the right channel
of the S/PDIF In is routed to OUT1. Note that this option is solely for
monitoring/mixing purposes — the S/PDIF In will not record in reverse when
this option is checked.
5. Selection five connects the Audiophile hardware analog inputs 1 & 2 directly to
the Audiophile's hardware analog outputs 1 & 2. For example, if "H/W In 1/2"
were selected, any signal present at the IN1 port will be copied to OUT1, and any
signal present at the IN2 port will be copied to OUT2.
20