Temperature Programs - Lux Products SMART TEMP TX1500U Installation And Operating Instructions Manual

STATIC NOTICE: This thermostat is protected against normal static electric
discharges, however to minimize the risk of damaging the unit in extremely
dry weather, please touch a grounded metal object before touching your
thermostat.

TEMPERATURE PROGRAMS:

By default, this thermostat has 4 separate program periods for both Heat and
Cool mode, they are: MORN, DAY, EVE, and NITE. Each period ends at the
start time of the following period. The heat programs are set in HEAT mode,
and the cool programs are set in COOL mode.
NOTE: If the thermostat is configured to use only 2 periods per day instead
of 4 (HARDWARE SETUP OPTIONS), the thermostat will only use the DAY
and NITE periods. The MORN and EVE periods will not be visible on the
screen.
SET TEMPERATURE PROGRAMS: Move the Set Slide switch to the TEMP
PROG position. Programming will start with all 5 weekdays, Monday
through Friday (all grouped together). Use the UP/DOWN buttons to adjust
the start time for the MORN period, then press the NEXT button to advance.
Use the UP/DOWN buttons to adjust the set temperature for the MORN
period, then press the NEXT button to advance. Now adjust the start time
and set temperature for the DAY period, pressing the NEXT button after each
to advance. Continue with these same steps to adjust the start times and set
temperatures for the EVE and NITE program periods.
When the NITE period is finished for the weekdays, the thermostat will
advance forward to the Saturday program, with the MORN period start time
flashing. Perform the same steps that you used for setting the weekday
periods, pressing the NEXT button to advance through each flashing value.
When the Saturday NITE period is finished, the thermostat will advance
forward to the Sunday program, with the MORN period start time flashing.
Perform the same steps that you used for setting the Saturday periods,
pressing the NEXT button to advance through each flashing value. Return
the Set Slide switch to the RUN position when you are finished.
22