Belkin F5D8236TT4 User Manual page 46

UsINg THe Web-based adVaNCed UseR INTeRfaCe
sections
1 2 3 4 5 6 7 8 9 10
table of contents
Using Wi-fi Protected setup (WPs)
WPS recommends that you set up WPA/WPA2 (described on page 46)
as your wireless security. WPS does not provide additional security, but
rather, simplifies the addition of wireless devices to your wireless network.
You may use either the Push Button Configuration (PBC) method or PIN
method to allow a device access to your wireless network.
PBC: Push and hold the WPS button located on the front of your Router
for three seconds and the security LED will flash, indicating that WPS
has been initiated. Then, initiate WPS on the client device within two
minutes. (Refer to your client's documentation on this procedure.) The
wireless device and Router will automatically exchange a security key
and establish a secure connection.
PIN: The client device has a WPS PIN number (eight digits) that will be
provided to you when you initiate the connection to the Router. Enable
WPS through the screen illustrated to the right. Enter the client's PIN
into the Router's internal registrar (accessed through this screen).
The client will be securely enrolled into your wireless network within
two minutes.
44
N Wireless Router