Connection Steps - Krell Industries Evolution 202 Owner's Reference Manual

Connection Steps

Position the power supply and preamplifier where you intend to use them in your
system. Do not move the connected chassis after they are assembled.
The following steps describe how to connect an Evolution 202 preamplifier to your
system:
1.
Connect the power supply chassis and preamplifier chassis with the 12-pin DC
cable provided, using the DC power connectors (24) on the back panels.
2.
Neatly arrange and organize wiring to and from the Evolution 202 preamplifier
and all components. Separate AC wires from audio cables to prevent hum or
other unwanted noise from being introduced into the system.
3.
Connect the outputs of your source equipment to the appropriate CAST (18),
balanced (15), single-ended (16), or tape inputs (17) on the Evolution 202.
4.
Connect the appropriate main outputs (20) on the Evolution 202 to your ampli-
fier.
5.
Connect the supplied AC power cord to the IEC power cord receptacle (27).
6.
Plug the AC power cord into AC power. The front panel display (3) scrolls
through
EVOLUTION 2 SOFTWARE VERSION,
indicating that the Evolution 202 preamplifier is in stand-by mode. The scrolling
stops when the Evolution 202 is ready to be powered on.
Note
Use only the power cord provided with the preamplifier channel to make the connec-
tion to AC power. Operation with a power cord other than the one supplied by Krell
could induce noise, limit current, or otherwise impair the ability of the preamplifier chan-
nel to perform optimally.
and the red stand-by LEDs illuminate (7),
27