Name Of Parts - Fujitsu ASTG24LVCA Operating Manual

NAME OF PARTS

Fig. 1 Indoor Unit
Operating Control Panel (Fig. 2)
MANUAL AUTO button
●
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
●
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
●
When the forced cooling operation starts
by any chance, press the START/STOP but-
ton to stop the operation.
●
Please press the button at FILTER INDICA-
TOR RESET.
Indicator (Fig. 3)
Remote Control Signal Receiver
OPERATION Indicator Lamp (green)
TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 16 Auto Restart).
ECONOMY Indicator Lamp (green)
DEFROST Indicator Lamp (green)
Intake Grille (Fig. 4)
Front Panel
Air Filter
Airflow Direction Louver
Right-Left Louver
(behind Airflow Direction Louver)
Drain Hose
Air Cleaning Filter
Remote Controller (Wired/Option)
Fig. 5 Remote Controller
Signal Transmitter
MODE button
10°C HEAT button
SET TEMP. button (
ECONOMY button
SLEEP button
TIMER MODE button
FAN button
START/STOP button
SET button
SWING button
TIMER SET ( / ) button
CLOCK ADJUST button
TEST RUN button
● This button is used when installing the air
conditioner, and should not be used un-
der normal conditions, as it will cause the
indoor unit's thermostat function to oper-
ate incorrectly.
● If this button is pressed during normal op-
eration, the indoor unit will switch to test
operation mode, and the Indoor Unit's OP-
ERATION Indicator Lamp and TIMER
Indicator Lamp will begin to flash simulta-
neously.
● To stop the test operation mode, press the
START/STOP button to stop the air
conditioner.
RESET button
Remote Controller Display (Fig. 6)
Transmit Indicator
Fan Speed Display
SWING Display
Timer Mode Display
Clock Display
Temperature SET Display
Operation Mode Display
SLEEP TIMER Display
/ )
En-4