Pedal; Amb; Amp Simulator; Editing Other Parameters - Korg Toneworks AX1B Owner's Manual

PEDAL

This provides effects which can be controlled using
the expression pedal. PEDAL provides volume pedal,
PEDAL-mod (modulation-type effects), and PEDAL-
amb (ambiance-type effects).
ENTER key: Turn the effect on/off (the type name
is displayed when on, and "OFF" when
off)
TYPE [√]/[®] keys: Select the effect type
VALUE [-]/[+] keys: Specify the value of the param-
eter assigned to each effect
type (
PEDAL-mod cannot be used simultaneously
with MOD effects. One or the other effect will
be turned off. Also, if the MOD effect is auto-
matically turned off, turning PEDAL off or se-
lecting an effect other than PEDAL-mod will au-
tomatically turn it on once again. Similarly,
PEDAL-amb and AMB effects cannot be used
simultaneously.

AMB

This provides spatial effects such as reverb and delay.
ENTER key: Turn the effect on/off (the type name
is displayed when on, and "OFF" when
off)
TYPE [√]/[®] keys: Select the effect type
VALUE [-]/[+] keys: Specify the value of the param-
eter assigned to each effect
type(

Amp simulator

The amp simulator simulates the acoustical charac-
teristics of an amplifier.
It is particularly effective when you are not using an
amp (i.e., when you are using headphones or con-
necting directly to a mixer, hard-disk recorder, or au-
dio system etc.).
ENTER key: Turn the effect on/off (the type name
is displayed when on, and "OFF" when
off)
TYPE [√]/[®] keys: Select the type of amp
p.52–54)
p.54)
NR
Adjust the depth of noise reduction. Raising this value
will produce more noise reduction. Normally you will
adjust this so that you do not hear obtrusive noise
when the strings are lightly muted.
VALUE [-]/[+] keys: Adjust the depth of noise re-
duction
It is not possible to turn noise reduction off.
If this value is raised excessively, the sound
may be cut off prematurely, depending on the
device that is connected. If this occurs, reduce
the value.

3. Editing other parameters

LEVEL

Adjust the level for each program.
Depending on the DRIVE or TONE settings, the out-
put sound may be distorted (clipped), so adjust this
parameter so that the sound is not distorted.
VALUE [-]/[+] keys: Set the level accordingly
The volume of each program (each tone) will
change depending on the bass you use. Ad-
just the level that is appropriate for your bass.

RENAME

Here you can specify a name for each program.
TYPE [√]/[®] key: Select the character location
(the selected character will
blink)
VALUE [-]/[+] keys: Select the character
Simultaneously pressing [+] and [-] will insert a space
(blank).
The following characters and symbols are available.
Edit mode
15