Setting Up Your Lcd Tv; Installing Remote Control Batteries; Connecting An Antenna; Connecting Cable Or Satellite Tv - Dynex DX-LCDTV19 User Manual

07-398_DX-LCDTV19.fm Page 5 Tuesday, August 14, 2007 11:33 AM

Setting up your LCD TV

# Button
10 PICTURE
11 MTS/SAP
12 FAVORITE
13
14 DISPLAY
15 SLEEP
16 RECALL
17 EXIT
18 AUDIO
19 CH.LIST
Setting up your LCD TV

Installing remote control batteries

To install remote control batteries:
1 Remove the battery compartment cover.
2 Insert two AAA batteries into the battery compartment. Make sure
that you align the + and – symbols on the batteries with the +
and – symbols inside the battery compartment.
3 Replace the battery compartment cover.
Notes: Make sure that there is no obstruction between the remote control
and the remote sensor on your LCD TV.
Keep the remote control away from heat sources or humid areas.
Strong light may affect the signal between the remote control and the
remote sensor on your LCD TV. If the remote control does not work,
change the position of the remote control.
Make sure that the batteries are alkaline batteries. Batteries must be of
the same type.
Do not mix old and new batteries.
Do not use rechargeable batteries.
Description
Press one or more times to
select a picture mode. You can
select Personal, Standard, Mild,
or Fresh.
Press to select the audio mode.
You can select Stereo, Mono, or
SAP (second audio program).
Press to open the favorite
channel list.
Press to turn your LCD TV on or
off.
Press to display channel
information.
Press to set the sleep timer.
Press to go to the previously
viewed channel.
Press to close the on-screen
menu.
Press to select the audio mode.
Press to open the channel list.

Connecting an antenna

Caution: Do not bend the bronze wires on the cables.
To connect an antenna:
1 Make sure that your LCD TV is turned off.
2 Plug one end of a 75 ohm cable (not included) into the ANT IN
jack on the back of your LCD TV.
3 Plug the other end of the cable into the outside antenna jack.
Notes: To improve picture quality in an area with poor signal reception,
install a signal amplifier.
If you want to connect two TVs to the antenna, install a two-way signal
splitter.

Connecting cable or satellite TV

To watch cable or satellite TV, you need a TV tuner device or a cable or
satellite TV converter box.
There are two ways to connect cable or satellite TV to your LCD TV.
Option 1: To connect cable or satellite TV:
1 Make sure that your LCD TV and converter box are turned off.
2 Connect a 75 ohm cable (not included) to the RF jack on the cable
or satellite TV converter box and to the ANT IN jack on the back of
your TV.
Caution: Do not bend the bronze wires on the cables.
3 Connect one end of a 75 ohm cable (not included) to the cable jack
on the cable or satellite TV converter box and to the cable or
satellite TV wall jack.
4 Set the channel switch on the cable or satellite TV converter box to
3 or 4.
5 Turn on your LCD TV and the converter box, then tune your LCD TV
to the same channel you set the channel switch to.
6 Use the cable or satellite TV remote control to tune channels.
Option 2: To connect cable or satellite TV:
1 Make sure that your LCD TV and cable or satellite converter box are
turned off.
2 Connect audio and video out jacks on the cable or satellite TV
converter box to the AUDIO IN and VIDEO IN jacks on the back of
your TV.
5